Your cart is currently empty.
A simple and effective solution to manually turn your cooling fan on and keep it on even if the factory thermostat has shut it off. Will not affect factory performance. Fan will continue to operate in factory mode even if switch is off.
This kit is designed to be plug and play with most polaris machines including:
RZR, RANGER, SPORTSMAN (may NOT fit RZR TURBO 1000)
Should also fit many Can Am machines with same plug. Outlander, Renegade, Maverick
NOTE: If the 2 pin connector on your FAN wire has the MALE connector with female pins and has ground in position (A) which is usually a black wire and 12v+ in position (B) which is usually a blue wire, then it should work. (the male connector is the connector with the visible green rubber seal in the pictures) So long as this male connector is the one that you have on the wire attached to your fan then this should be the proper kit. for plug n play operation.
Simply plug this T harness into the fan connector, run the wires to the switch and the 12v+ wire to your battery (or ignition source) and you're done. Painfully simple to install and only takes a few minutes in most cases.
Copyright © 2000-2017 Advance MCS Electronics - All Rights Reserved
Developed by iTiSdESign Site Map